Как лучше стабилизировать ток от источника питания 1,5-3 В?

 
RU Тихон #09.08.2008 13:10
+
-
edit
 

Тихон

опытный

Сабж.

В идеале хотелось бы современную микросхему с минимумом обвеса и без необходимости настройки режима и т.д..

Есть такое?
"Наиболее высоконравственны обычно те, кто дальше всех от решения задач" (с)  
+
-
edit
 

ILPetr

новичок

Если подойдет линейный вариант, то проще лампочки ничего нет :-) .
Подпись  
EE Татарин #22.08.2008 10:57
+
-
edit
 

Татарин

координатор
★★★★☆
Линейные стабилизаторы от "Микрочип"
...А неубитые медведи делили чьи-то шкуры с шумом. Боюсь, мы поздно осознали, к чему всё это приведёт.  
RU Тихон #22.08.2008 20:03
+
-
edit
 

Тихон

опытный

О, пасиб! :)
"Наиболее высоконравственны обычно те, кто дальше всех от решения задач" (с)  
RU Alexandrc #22.08.2008 20:58
+
-
edit
 

Alexandrc

аксакал

А такое не подойдет?

MAX1703 1-Cell to 3-Cell, High Power (1.5A), Low-Noise, Step-Up DC-DC Converter - Overview

Overview: The MAX1703 is a high-efficiency, low-noise, step-up DC-DC converter intended for use in battery-powered wireless applications. It uses a synchronous-rectified pulse-width-modulation (PWM) boost topology to generate a 2.5V to 5.5V output

// www.maxim-ic.com
 

The MAX1703 is a high-efficiency, low-noise, step-up DC-DC converter intended for use in battery-powered wireless applications. It uses a synchronous-rectified pulse-width-modulation (PWM) boost topology to generate a 2.5V to 5.5V output from battery inputs, such as one to three NiCd/NiMH cells or one Li-Ion cell. The device includes a 2A, 75mΩ, N-channel MOSFET switch and a 140mΩ, P-channel synchronous rectifier.

With its internal synchronous rectifier, the MAX1703 delivers up to 5% better efficiency than similar nonsynchronous converters. It also features a pulse-frequency-modulation (PFM) low-power mode to improve efficiency at light loads, and a 1µA shutdown mode.

The MAX1703 comes in a 16-pin narrow SO package and includes an uncommitted comparator that generates a power-good or low-battery-warning output. It also contains a linear gain block that can be used to build a linear regulator.

For lower-power outputs and a smaller package, refer to the MAX1700/MAX1701. For dual outputs (step-up plus linear regulator), refer to the MAX1705/MAX1706. For an on-board analog-to-digital converter, refer to the MAX848/MAX849.

The MAX1703 evaluation kit is available to speed designs.
Но вы там держитесь!  

в начало страницы | новое
 
Поиск
Настройки
Твиттер сайта
Статистика
Рейтинг@Mail.ru